Weird deal. My trim buttons engine/binnacle aren't working properly. Sometimes it will trim up but not down, or down and not up. It's clicking in a module bolted next to middle plug?
468x80 Banner
Collapse
Announcement
Collapse
No announcement yet.
Trim Switch Not Working Right...Ideas?
Collapse
X
-
Originally posted by Ibtsoom View PostTrim relay is bad if it happens with both switches. Should be fairly simple to replace and relatively inexpensive. 20 or 30 bucks I'm guessing."GET OFF MY REEF!"
Comment
-
Trace the wires from the pump back to the relays. Should be under the cowling - Depending upon the year it could just be one big (unfortunately pricey) relay or more likely there are 2. Hopefully the wires (blue and green I think) are just a bit corroded on the connectors or the ground is corroded.Shut up and FISH!!
Comment
-
Usually when the relay starts acting up it's because the internal contacts have become pitted
and not enough current will flow to the trim motor. I think I paid around $100 and changed it
out myself. If any water reached the trim motor the same thing will happen, so pick your poison.
Good luck Kenny.
Comment
-
Comment