My buddy has just bought a 1998 20' gulf coast with a 2007 etec (150hp). The bow constantly bounces at any speed over 30mph like the engine trim is too far out. The trim is at 0 and the jack plate is all the way down. I was wondering if the wrong engine/length shaft was installed or if there is an adjustment that can be done. Does any one have any specs or knowledge in this arena?
468x80 Banner
Collapse
Announcement
Collapse
No announcement yet.
Gulf Coast porposing(sp?)
Collapse
X
-
Need to add some trim tabs, and should have a 20" shaft motor.Bryan Evans
Boat Werx of Texas
(AKA Evans Marine Services)
4340 19th St.
Bacliff, Texas 77518
http://evansmarine.net
http://boatwerxtx.com
main@boatwerxtx.com
281-559-BOAT (2628)
-
Originally posted by crabcab View PostMy buddy has just bought a 1998 20' gulf coast with a 2007 etec (150hp). The bow constantly bounces at any speed over 30mph like the engine trim is too far out. The trim is at 0 and the jack plate is all the way down. I was wondering if the wrong engine/length shaft was installed or if there is an adjustment that can be done. Does any one have any specs or knowledge in this arena?
Comment
-
Originally posted by crabcab View PostHow can i tell the length of shaft motor? Is it the length of the lower unit? Would it be in the VIN# of the engine?
Comment
Comment