If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I think I have one that is calibrated that is rated up to 36" that I can let go pretty cheap. Then I have a retractable one that goes to 25ft that would be a little more.
Eagle makes some pretty cheap ones. I have had one for years, but I never use it. I would sell it to you, but I dont know if it even works anymore. I think water temp comes standard on all of them that I know of. Check these out.
Yah I was looking at one for my boat just so I could tell when I was getting shallow when drifiting shell reefs... They don't sound good on an aluminum hull
Although I wouldn't want to drill into mine I was looking at the suction cup models... Not sure how they'd hold on when I get to moving etc.
Yah I was looking at one for my boat just so I could tell when I was getting shallow when drifiting shell reefs... They don't sound good on an aluminum hull
Although I wouldn't want to drill into mine I was looking at the suction cup models... Not sure how they'd hold on when I get to moving etc.
I might mount this on my rear hunt deck next to the engine... Perhaps it will clear... What do yall think about the suction cup model on painted aluminum?
Yah I was looking at one for my boat just so I could tell when I was getting shallow when drifiting shell reefs... They don't sound good on an aluminum hull
Although I wouldn't want to drill into mine I was looking at the suction cup models... Not sure how they'd hold on when I get to moving etc.
You can epoxy the transducer to the floor of the boat (inside) and if done right it will actually read better than if screwed to the transome.
"Nobody's so poor that democrats can't get rich screwing 'em."
boom
Eagle makes some pretty cheap ones. I have had one for years, but I never use it. I would sell it to you, but I dont know if it even works anymore. I think water temp comes standard on all of them that I know of. Check these out.
Comment