If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yeah I found it...it was in the very back...that coat of JB weld I put on came off when we were driving which was why it was good for the first little bit then we probably hit some mud or something and it came off.
Gonna sand it down and try again with some different JB Weld. Hope it works....any tips on getting this small little pin sized leak plugged in the bottom of the aluminum flats boat would be great.
water weld ( temp fix ) about same as JB weld... u need to fina a guy who can weld aluminum, if its just a little spot prob be really cheap
Tweet
Comment